Keri Systems BioPointe Users Manual - Manual (Page 44)

Administering the BioPointe
43
4.5.4 Enabling or Disabling the Alarm
There are two events that can trigger an alarm indication from the BioPointe:
• The tamper switch of the BioPointe was triggered, and
The following steps describe how the alarm indication in the BioPointe can be enabled or disabled. The user
would find this operation used oftentimes especially during installation or maintenance when preventing false
alarm triggers is necessary.
Steps LED and Buzzer Status
Press , , .
The LEDs will light up as shown in 1. The sensor
will also light up, waiting for a master fingerprint
to be verified.
Place the master finger on the sensor to
verify.
a) If the finger is successfully verified as a
master, the 1
st LED will blink green briefly as
shown in 2(a). The 2 nd LED will blink slow in
green and while the 3 rd LED will blink slow in
amber next. Proceed to step 3.
b) If the finger is not successfully verified as a
master, the 1
st LED will blink red briefly as
shown in 2(b). Operation will cease and return to
normal mode.
Press or , the number that
corresponds to the appropriate mode,
followed by to confirm.
Or,
Press to exit.
0 corresponds to the Disable , while
1 corresponds to the Enable .
When the mode has been successfully set, the 1 st
LED will blink green briefly as shown in 3.
1
1 AMBER RED
4 1
2b
RED
→AMBER
Master verification fails
2
GREEN
→AMBER
GREEN
2a
GREEN
→AMBER #
*
3
1 0 3
AMBER