Keri Systems BioPointe Users Manual User Manual
Page 50
Performing Authentication with the BioPointe
49
One-to-Many Matching (or Identification)
With one-to-many matching, you need not remember your ID. However, the user must note that this
matching process is carried out at a higher security level.
Before one-to-many matching can be used, the mode must first be enabled. To enable this mode, you
can refer to Chapter 4 – Administering the BioPointe.
Note that one-to-many matching mode will be automatically disabled if the Multiple Fingerprint
Matching feature is configured at 2 or 3. For more information on this feature, you can refer to
Chapter 3 – Features.
With the one-to-many matching mode enabled, press the key 2 times.
Place your finger on the sensor, removing it only when the sensor light goes off.
If the 1
st
LED lights up in green, the authentication is successful.
If the 1
st
LED lights up in red, the authentication fails.
(There is no automatic retry for one-to-many matching.)
1
2
3