Keri Systems BioPointe Users Manual - Manual (Page 39)

Administering the BioPointe
38
4.4.7 Deleting a Single Record
The following steps describe how a record can be deleted. The record can belong to any of the three
authentication properties. It can also be a master or a user.
Steps LED and Buzzer Status
Press , , .
The LEDs will light up as shown in 1. The sensor
will also light up, waiting for a master fingerprint
to be verified.
Place the master finger on the sensor to
verify.
a) If the finger is successfully verified as a
master, the 1
st LED will blink green briefly as
shown in 2(a). Proceed to step 3.
b) If the finger is not successfully verified as a
master, the 1
st LED will blink red briefly.
Operation will cease and return to normal mode.
When the 2 nd LED starts to blink slowly in red,
Enter the 4-digit ID of the record to be deleted
3 .
a) If the ID exists, the record will be successfully
deleted. The 1
st LED will blink green briefly as
shown in 3(a). Operation is completed and will
return to normal mode.
b) If the ID does not exist, the deletion cannot be
carried out. The 1
st LED will blink red briefly as
shown in 3(b). Operation ceases and will return
to normal mode.
3
You can also flash a card, if the card ID is the one you are going to delete.
1
1
AMBER RED
2
2a
GREEN
→AMBER
RED GREEN
2b
RED
→AMBER
Master verification fails
3
GREEN
→AMBER
3a
RED
→AMBER
3b
Fail to delete (ID does not exist)
5