Neuspeed 49.10.93 - Manual (Page 7)

Page 7
20. Remove coolant hose connecting throttle body to heater core.
Cut hose 2” from bend and position clamps as shown, set-aside.
21. Replace coolant hose connecting throttle body to expansion
tank T-fitting with 2” modified hose as shown. Replace coolant
hose connecting T-fitting to the radiator coolant hose with
supplied
5 /
16
” X 12” hose. Install one end of supplied 5 /
16 ” X 11”
hose to 90-degree fitting on throttle body and the other end to
heater core.
22. BEETLE ONLY: Cut 1 1 /
4
” off the throttle body side of
coolant hose. Re-install and position factory hose clamp as
shown.
23. BEETLE ONLY: Connect new coolant hose with barb
fitting supplied to throttle body coolant hose and route opposite
end to expansion tank along back of firewall. Trim to fit, keeping
away from exhaust and engine belts, and secure with tie-wraps.