Neuspeed 64.10.15 - Manual

NEUSPEED • 3300 Corte Malpaso • Camarillo, CA 93012 • 805.388.7171 • 805.388.0030 FAX
[email protected] • www.neuspeed.com
POWER MODULE – PART #64.10.15
FITS: 2014-UP AUDI A3(8V) 1.8 TSI/2.0 TSI AND 2015-UP VW MK7 GTI
PARTS LIST: 1– POWER MODULE TOOLS REQUIRED: 1 – T25 TORX
1– ADHESIVE BACKED VELCRO 1 – T40 TORX (Audi)
1. Recommended to install on cool engine.
2. Lift up engine cover to remove.
3. Sensor Location: MAP sensor is on top of the
intake manifold (shown). Boost sensor is on
the plastic Air Charge Pipe located just below
the A/C compressor.
4. Clean surface on side of ECU just in front of
battery and stick-on NEUSPEED Power
Module with supplied Velcro. Route wire
harness toward engine underneath air intake
hose between air filter box and turbo.
5. Squeeze locking tap on end of MAP
connector then disconnect electrical
connection.
6. Connect NEUSPEED Power Module harness
in-line as shown.
7. Boost sensor is a little harder to access.
Either reach down in front of alternator to
just below A/C compressor to get to boost
sensor in Air Charge Pipe or see step#8.
8. From underneath vehicle remove lower
engine splash pan (T25/T40 Torx Screws) to
access boost sensor in Air Charge Pipe just
below A/C compressor.
9. Connect NEUSPEED Power Module harness
in-line as shown.
10. Re-install engine cover and if removed
engine splash pan.
11. NEUSPEED Power Module has a (2) position
power switch access from the back side.
DOWN position for Premium fuel 91+ octane
(5PSI increase) and UP position for 100+
Race fuel (7PSI increase). NOTE: Only use
RACE setting when fuel in gas tank is 100
octane or higher.
12. ECU trims will adapt within 20 miles of
driving. Enjoy!
Copyright 2015, NEUSPEED ® .
All rights reserved. Reproduction in whole or in part prohibited.
DOC. 64.10.15 Rev. 12.03.15