Default-router, Syntax description, Defaults – Cisco 32369 User Manual
Page 20: Command modes, Usage guidelines, Examples, Related commands
To specify the default router list for a Dynamic Host Configuration Protocol (DHCP) client, use
the default-router DHCP pool configuration command. Use the no form of this command to
remove the default router list.
default-router address [address2 ... address8]
DHCP pool configuration
This command first appeared in Cisco IOS Release 12.0(1)T.
The IP address of the router should be on the same subnet as the client subnet. You can specify up
to eight routers in the list. Routers are listed in order of preference (address1 is the most preferred
router, address2 is the next most preferred router, and so on).
The following example specifies 10.12.1.99 as the IP address of the default router:
ip dhcp pool
Specifies the IP address of a router. One IP address is required,
although you can specify up to eight addresses in one command line.