Cisco 32369 - Manual (Page 36)

Command Reference
36 Release 12.0(1)T
netbios-name-server
To configure NetBIOS Windows Internet Naming Service (WINS) name servers that are available
to Microsoft Dynamic Host Configuration Protocol (DHCP) clients, use the netbios-name-server
DHCP pool configuration command. Use the no form of this command to remove the NetBIOS
name server list.
netbios-name-server address [address2...address8]
no netbios-name-server
Syntax Description
Defaults
None
Command Modes
DHCP pool configuration
Usage Guidelines
This command first appeared in Cisco IOS Release 12.0(1)T.
One IP address is required, although you can specify up to eight addresses in one command line.
Servers are listed in order of preference (address1 is the most preferred server, address2 is the next
most preferred server, and so on).
Examples
The following example specifies the IP address of a NetBIOS name server available to the client:
netbios-name-server 10.12.1.90
Related Commands
dns-server
domain-name
ip dhcp pool
netbios-node-type
address Specifies the IP address of the NetBIOS WINS name server.