Retrieve information from logtag – ThermoWorks HAXO-8 LOGTAG TRANSIT RECORDERS User Manual User Manual

Page 26

Advertising
background image

24

LogTag Analyzer User Guide (1.9)

Alert condition
present

Single flash of red LED
every 4 seconds

ƒ displayed when the LogTag has detected an

alert

condition (see "Alert Processing" on page 32)

and the Alert LED has been activated

If an alert is present you cannot determine if the
unit is still logging or has finished its log cycle. It

was deemed more important to ensure an alarm

condition is not overlooked, and 8 seconds

seemed to long a time to still achieve that

If the Alert LED has not been activated during
configuration, in essence the visual indicators

have been disabled, and the green LED will flash

every 4 or 8 seconds as above.

Communication The green LED will

flash occasionally

ƒ during communication with the interface the

green LED will flash occasionally; no information
is conveyed in this.

Start button

press

red LED glows faintly

ƒ This is by design but conveys no information.

Retrieve information from
LogTag

When you are ready to view the recordings that are stored within the LogTag, just place
the LogTag into the Interface Cradle as before. If the LogTag is still recording when you
go to retrieve the readings it will continue to record without interruption so you will be
able to download again later if you choose.

If the LogTag has readings stored within its memory, the software will automatically start
to retrieve a copy of the recording contained within the LogTag and will also display an
animated picture during the download process, similar to the following picture.

Once the readings have been successfully retrieved from the LogTag(s), the software will
display the information for you. The chapter "

Results from LogTag

" explains in more

detail the information that is displayed to you as a result of retrieving the recorded
readings from LogTag(s).

Advertising