Alert processing – ThermoWorks HAXO-8 LOGTAG TRANSIT RECORDERS User Manual User Manual

Page 34

Advertising
background image

32

LogTag Analyzer User Guide (1.9)

Alert Processing

The LogTag can display a visual alert if one or more of the configured alert conditions
have been met. An alert condition can be a single alert reading (a reading above the
upper or below the lower threshold value), a combination of consecutive alert readings or
a total of alert readings encountered during the trip.

The threshold parameters are identified in LogTag Analyzer when the LogTag's readings
are downloaded and displayed.

Please note that matching these to known conditions of interest in your monitoring
program may require some information about the effects of exposure to different
durations of out-of-range humidity and/or temperatures.

As with the other logging parameters these are adjusted in the "Configure LogTags for
use" screen.

The following table describes each configurable option.

Function

Purpose

Enable the Alert (Red)

indicator when

This determines whether or not the red light should activate when

an alert condition has been detected. An alert occurs when one or

more of the conditions described below have been met. When an

alert condition has occurred, this indicator will flash at a regular

interval.

Readings below X or

above Y

You can set the upper threshold limit and lower threshold limit by

entering the appropriate information in the boxes. If readings never

go below X or above Y then the alert indicator will not activate. If
the reading does go below X or above Y the alert indicator may

light up, dependent on the alert conditions. Charts will display alert

readings according the settings made in the

Charts section of the

'Options' Screen.

Advertising