Replacing a, To r, Step 3 – Cisco 3200 User Manual
Page 228
12-20
Cisco TelePresence System 3200
OL-14521-01
Chapter 12 Field-Replaceable Unit Guide
Replacing a Microphone—Part Number CTS-MIC=
Step 3
From the underside of the tabletop, remove the two screws and washers that secure the microphone.
Note
Retain the screws and washers.
Step 4
Disconnect the microphone from the codec or audio/video extension unit.
Step 5
Pull the cable out through the hole and set the microphone aside.
Note
If the microphone is a second row microphone, you might have to disconnect some cable ties between
the cable and the audio/video extension unit.
Step 6
Pull the replacement microphone cable through the hole in the tabletop.
Step 7
From the underside of the tabletop, attach the microphone by screwing in the two screws.
Step 8
Run the microphone cable to the codec or audio/video extension cable in a similar manner as the original
cable and attach it to the appropriate connection on the codec or audio/video extension unit.
Step 9
Power on the system by turning the power switches to the On position on the two left PDUs, single right
PDU, and (if present) auxiliary control unit or PDU on the rear center of the display assembly.
Step 10
Open a browser on a computer connected to the network.
Step 11
Type in the IP address of the Primary codec. Enter the required information at the login screen. The
Cisco TelePresence Administrator window appears.
Step 12
Verify the status of the Cisco Unified Communications Manager (seen in the lower left portion of the
window) is Enabled/Up.
Step 13
Select Hardware Setup to verify the cameras, displays, speakers, and microphones are working
properly.
Refer to the
for your software release for more
information.
Step 14
If required, reattach the projector assembly.
See
Chapter 8, “Assembling the Remaining Cisco TelePresence Elements”
Step 15
Perform the microphone test to verify that the microphone is working properly.
See the
“Setting Up the Microphones” section on page 10-18
for more information.
Replacing a Microphone With a Microphone Extension Cable
If your microphone uses a microphone extension cable between the codec or audio/video extension unit
and the microphone, complete the following procedure to replace the microphone.
Step 1
If you are replacing a first row left or right microphone, or a second row microphone, skip to
.
Step 2
If you are replacing the center microphone, follow these steps.
a.
Loosen, but don’t remove, the mounting screws holding the projector assembly to the underside of
the center tabletop.
b.
Remove the projector assembly by sliding the unit to the left and away from the mounting screws.