Cisco 3200 - Manual (Page 241)

12-33
Cisco TelePresence System 3200
OL-14521-01
Chapter 12 Field-Replaceable Unit Guide
Replacing a Second Row Table Top Section
Removing and Replacing a Second Row Table Top Section
Step 1 Remove the privacy panel from the following table top sections:
• The table top section to be replaced
• All table sections to the right of the table top section to be replaced
Note See Chapter 7, “Building the Second Row Table Assembly” for expanded views of the privacy
panels.
Step 2 Remove the microphone from the table top section to be replaced. See Figure 7-38 for an expanded view
of the microphone and its attachment hardware.
Step 3 Disconnect the microphone from the audio/video extension unit, route the cable through the table top
section, and remove the microphone.
The microphone cable routes from the audio/video extension unit to the table top section by way of the
cable gutters on the second row table. The gutters are behind the privacy panels that you removed in
Step 1 .
Step 4 If required, remove the cable cover for the right end privacy panel as shown in Figure 7-46 and remove
cable ties that bundle the microphone cable with other cables.
Step 5 Remove the privacy panel alignment bracket.
See Chapter 7, “Building the Second Row Table Assembly” for the location of the privacy panel
alignment brackets.
Step 6 If you are replacing the left or right tabletop end, remove the privacy panel end piece and panel end
brace. See
Figure 7-47 for the privacy panel end piece locations and Figure 7-30 for the panel end brace
locations.
Step 7 Remove the privacy panel hangers from the table legs that support the table top section to be replaced.
See Chapter 7, “Building the Second Row Table Assembly” for the privacy panel hanger attachment
points and screw locations.
Step 8 Remove the floating bracket on each side of the table top section to be replaced.
See Chapter 7, “Building the Second Row Table Assembly” for the floating bracket attachment points
and screw locations.
Step 9 Remove the gutter panel for the table top section to be replaced.
See Chapter 7, “Building the Second Row Table Assembly” for the gutter panel attachment points and
screw locations.
Step 10 Remove the gutter and privacy panel support brackets from the table legs that support the table top
section to be replaced.
See Chapter 7, “Building the Second Row Table Assembly” for the screw locations for the gutter and
privacy panel support brackets.
Step 11 Remove the screws from the table legs that support the table top section.