Cisco 3200 User Manual
Page 243
12-35
Cisco TelePresence System 3200
OL-14521-01
Chapter 12 Field-Replaceable Unit Guide
Replacing a Second Row Table Top Section
Step 28
Attach the privacy panel hangers to the table legs that support each side of the table top section.
See
Chapter 7, “Building the Second Row Table Assembly”
for the privacy panel support bracket
attachment points and screw locations.
Step 29
Attach the privacy panel alignment bracket.
See
Chapter 7, “Building the Second Row Table Assembly”
for the location of the privacy panel support
brackets.
Step 30
If you are replacing the left or right tabletop end, attach the privacy panel end pieces and panel end brace.
See
for the privacy panel end piece locations and
Step 31
Insert the microphone cable into the hole in the table top and route the cable through the cable gutters
to the audio/video extension unit.
Step 32
Connect the microphone cable to the audio/video extension unit.
Step 33
Reconnect the microphone to the new table top section.
See
for microphone installation instructions.
Step 34
Attach the privacy panels to the table sections.
Note
If required, adjust the privacy panel sections so that there is an equal amount of space between
each section.
Step 35
If required, replace the cable cover for the right end privacy panel as shown in
and add cable
ties to bundle the microphone cable with other cables.
Step 36
Reposition the second row table so that the trailing edge of the first row table is exactly 59 inches
(150 cm) behind the leading edge of the second row table. See
for the correct second row
table positioning.