Cisco 3200 - Manual (Page 240)

12-32
Cisco TelePresence System 3200
OL-14521-01
Chapter 12 Field-Replaceable Unit Guide
Replacing a Second Row Table Top Section
Step 18 Insert the draw bolts or cam locks and tighten them between the new table top section and the adjoining
table top sections. See
Chapter 6, “Building the First Row Table Assembly” for the location of the draw
bolts or cam locks.
Step 19 Attach the legs to the table top sections with the screws. See Chapter 6, “Building the First Row Table
Assembly” for the location of the table legs and screw attachment locations.
Step 20 Reconnect the microphone to the new table top section.
Step 21 Route the microphone cable to the audio/video extension unit and connect the cable to the unit.
See Figure 6-13 for microphone installation instructions.
Step 22 Close the table door.
Step 23 If you removed the table door, replace the door.
See Figure 6-14 for table door installation instructions.
Replacing a Second Row Table Top Section
Complete these steps to replace a second row table top section.
Required Information, Tools, and Equipment
To remove and replace a second row table top, you need the following tools:
• Medium and large Phillips screwdriver
• 10 mm wrench
Tip A 10 mm open end ratcheting wrench is useful to loosen and tighten the draw bolts or cam locks.
• Furniture sliders (recommended but not required)
Note Furniture sliders are flat plastic pieces that you place under the table legs before you move the
table. Using furniture sliders can make moving the second row table easier.
Note Make sure to retain all screws, connectors, and other parts during the disassembly.