YSI 600LS - User Manual - Manual (Page 115)

Sondes Section 2
YSI Incorporated Environmental Monitoring Systems Operations Manual 2-109
Sondes with no optical (turbidity, chlorophyll, or rhodamine WT) probes enabled will display the
following menu.
If any optical probe is enabled in the Sensor menu, then the menu will appear as follows.
Choosing 3-Time Constant will display the following the following or a similar menu to reflect your
optical probe selection:
Recommended settings for time constants are turbidity 12, rhodamine WT 12, chlorophyll 12, BGA-PC 24,
BGA-PE 24, ODO 12, and “other” 4. Note that the time constant can be set independently for each optical
probe and that time constant choices are only available for activated sensors. Rhodamine WT would
appear in the display below if it had been activated as a sensor. All “other” sensors use the same time
constant as shown below.
------------Data filter setup----------
1-(*)Enabled
2-( )Wait for filter
3-Time constant=4
4-Threshold=0.001
Select option (0 for previous menu):
------------Data filter setup----------
1-(*)Enabled
2-( )Wait for filter
3-Time constant. . .
4-Threshold. . .
Select option (0 for previous menu):
------------Time constant ----------
1- Turbid=12
2- Chl=12
3- Other=4
Select option (0 for previous menu):