YSI 600LS - User Manual - Manual (Page 38)

Sondes Section 2
YSI Incorporated Environmental Monitoring Systems Operations Manual 2-32
CHECKING ADVANCED SETTINGS
Select Advanced from the Main menu. The following menu will be displayed.
Select Setup from the Advanced menu.
Make sure that, other than Auto sleep RS232, all entries are activated or deactivated as shown above.
For sondes which will be used in sampling studies where the user is present and observes readings in real-
time, Auto sleep RS232 should usually be “off‟. For sondes that will be used in unattended monitoring
studies, Auto sleep RS232 should usually be “on”. This is described in detail in Section 2.9, Sonde Menu.
When this setup is verified, press Esc or 0 to return to the Advanced menu.
Select 3-Sensor from the Advanced menu and make certain that the entries are identical to those shown
below.
----------------Advanced--------------
1-Cal constants
2-Setup
3-Sensor
4-Data filter
Select option (0 for previous menu):
-------------Advanced setup-----------
1-(*)VT100 emulation
2-( )Power up to Menu
3-( )Power up to Run
4-( )Comma radix
5-(*)Auto sleep RS232
6-(*)Auto sleep SDI12
7-( )Multi SDI12
8-( )Full SDI12
Select option (0 for previous menu): 0