YSI 600LS - User Manual - Manual (Page 174)

650 MDS Section 3
YSI Environmental Monitoring Systems Operations Manual 3-44
The two inserted entries can be moved either up or down in the list by highlighting them and pressing the
Up or Down arrow key while holding down the Enter key or completely deleted by highlighting the entry
and pressing the Left arrow key while holding down the Enter key as shown below.
Finally, the user should be aware of a timesaving tip that is displayed when the Filename entry is
highlighted. The tip allows much easier generation of Multi-Site Designations where the Filename is
identical for several files. To “copy” the Filename from the previous file to a new entry below, simply
highlight the new Filename block, press Enter and then enter site names and site numbers. The site list
will show these blanks in the Edit site list mode as shown on the left below, but when the site list is
accessed for logging studies the actual Filename will appear to avoid confusion. This is shown at the right
below. Note that, by using this tip, two new sites have been easily added to the BLUELAKE Multi-site list
with no need to enter “BLUELAKE” Filename for each new site.
Remember that, when editing your Site list, you will have no effect on the actual files which were
previously logged to 650 memory nor on the data in the files. See Section 3.6 below.