YSI 600LS - User Manual User Manual
Page 33
Sondes
Section 2
YSI Incorporated
Environmental Monitoring Systems Operations Manual
2-27
Figure 39
If your sonde has previously been used, the Main menu (rather than the # sign) may appear when
communication is established. In this case simply proceed as described below. You will not be required to
type “Menu”.
If you are unable to establish interaction with the sonde, make sure that the cable is properly connected. If
you are using external power, make certain that the YSI 6651 or 6038 power supply or other 12 vdc source
is properly working. Recheck the setup of the Com port and other software parameters. Also refer to
Section 6, Troubleshooting.
The sonde software is menu-driven. You select functions by typing their corresponding numbers. You do
not need to press Enter after choosing a selection. Type the 0 or Esc key to return to the previous menu.
Sonde Main Menu
------------------Main-----------------
1-Run 5-System
2-Calibrate 6-Report
3-File 7-Sensor
4-Status 8-Advanced
Select option (0 for previous menu):