Cisco 6400 - Manual (Page 18)

A-18
Cisco 6400 Equipment Module Configuration Guide
OL-1812-01
Appendix A Attribute Reference
Cross Connection
Transit Cost [srcost]
This is the cost of crossing the sub-network. This attribute is used by the
Threader to determine the lowest cost path when threading a service.
M
Numb (10)
Range=0-214748
3647 0
ATM LPort Associations
A Endpoint
LPort [sra_tp.srname]
This is the logical port designated as the A endpoint of the
cross-connection.
R | A
Text (32)
VPI [raa_vpi]
This is the VPI for the A endpoint. If you want to let Cisco Provisioning
Center auto-select the VPI, enter -1.
M | C
Numb (3)
Range=-3-255 -1
VCI [raa_vci]
This is the VCI for the A endpoint. If you want to let Cisco Provisioning
Center auto-select the VPI, enter 0.
M | C
Numb (5)
Range=-3-16383 -1
Enable Frame Discard [raa_frdisc]
This attribute specifies whether to enable frame discard.
W
Bool (5)
Z Endpoint
LPort [srz_tp.srname]
This is the logical port designated as the Z endpoint. of the
cross-connection.
R | A
Text (32)
VPI [raz_vpi]
This is the VPI for the Z endpoint. If you want to let Cisco Provisioning
Center auto-select the VPI, enter -1. This attribute is mandatory.
M | C
Numb (3)
Range=-1-255 -1
VCI [raz_vci]
This is the VCI for the Z endpoint. If you want to let Cisco Provisioning
Center auto-select the VPI, enter 0. This attribute is mandatory.
M | C
Numb (5)
Range=-1-16383 -1
Enable Frame Discard [raz_frdisc]
This attribute specifies whether to enable frame discard.
W
Bool (5)
ATM Attributes
Table A-8 Cross Connection (continued)
Attributes Acceptable
Values Default Values