Cisco 6400 - Manual (Page 24)

A-24
Cisco 6400 Equipment Module Configuration Guide
OL-1812-01
Appendix A Attribute Reference
NRP Internal PVC
Next-Hop IP Address [c4_remtipaadr]
The IP address of the remote end of the PVC sub interface.
W
Text (15)
Upper Layer Protocol [c4_protocol]
This is the upper layer protocol type.
W
Enum (14)
ip_broadcast,
ip_nobroadcast,
inarp, none
VC Class Attributes
QoS Class [c4_qos]
This indicates the class of service.
W
Enum (9)
NRP1 supports UBR
and nrt.VBR only.
NRP2 supports UBR
and nrt.VBR only.
NSP supports CBR
PCR [c4_pcr]
This is the peak cell rate, which is the maximum allowed cell
transmission rate (expressed in cells per second). It defines the
shortest time period between cells and provides the highest guarantee
that network performance objectives (based on cell loss ratio) are met.
W
Numb (10)
Range=0-214748364
7 365566
MCR [c4_mcr]
The minimum cell rate.
W
Numb (10)
Range=0-214748364
7 0
NRP-NSP Bandwidth [c4_az_bandwidth]
This is the A - Z bandwidth from the NRP/NRP2 to the NSP.
W
Numb (10)
Range=0-214748364
7 0
NSP-NRP Bandwidth [c4_za_bandwidth]
This is the Z - A bandwidth from the NSP to the NRP/NRP2.
W
Numb (10)
Range=0-214748364
7 0
Encapsulation [c4_encapsulation]
This is the encapsulation type.
W
Enum (10)
aal5ciscoppp,
aal5autoppp,
aal5snap, aal5mux
Virtual Template Attributes
Table A-9 NRP Internal PVC (continued)
Attributes Acceptable Values Default Values