Cisco 6400 - Manual (Page 19)

A-19
Cisco 6400 Equipment Module Configuration Guide
OL-1812-01
Appendix A Attribute Reference
Cross Connection
Circuit Type [ratype]
Specify the circuit type. It can be either a virtual circuit (VP) or virtual path
(VP).
C | P
Enum (2) "VC"
"VP"
Class of Service [raqos]
You can specify the class of service for ATM traffic. The class of service
determines which traffic descriptor you can select.
M | W | P
Enum (7) "CBR"
"ABR" "UBR"
"rt_VBR"
"nrt_VBR"
Fixed Round-Trip Time [ra_frtt]
This attribute specifies the round-trip time in milliseconds.
W
Numb (8)
Range=0-167000
00 0
A to Z Direction
Bandwidth (kbits/s) [sraz_bandwidth]
This is the bandwidth consumed by the A endpoint in the A to Z direction.
M | W | P
Numb (10)
Range=0-214748
3647 0
Primary logical port [sra_primtp]
This is the logical port used as the primary A side termination point when
this NC is using a backup UNI logical port.
R | A
Text (44)
Sustainable Cell Rate (cells/s) [raaz_scr]
SCR is the maximum average cell transmission rate that is allowed over a
given period of time on a given circuit. It allows the network to allocate
sufficient resources for guaranteeing the network performance objectives
are met.
W | P
Numb (10)
Range=0-214748
3647 0
Peak Cell Rate (cells/s) [raaz_pcr]
PCR is the maximum allowed cell transmission rate. It defines the shortest
time period between cells and provides the highest guarantee that network
performance objectives (based on cell loss ratio) will be met.
W | P
Numb (10)
Range=0-214748
3647 0
Minimum Cell Rate (cells/s) [raaz_mcr]
MCR is the minimum cell rate, which is the minimum allocated bandwidth
for a connection.
W | P
Numb (10)
Range=0-214748
3647 0
Table A-8 Cross Connection (continued)
Attributes Acceptable
Values Default Values