Cisco 6400 - Manual (Page 20)

A-20
Cisco 6400 Equipment Module Configuration Guide
OL-1812-01
Appendix A Attribute Reference
Cross Connection
Maximum Burst Size (cells) [raaz_mbs]
MBS is the maximum number of cells that can be received at the PCR. This
allows a burst of cells to arrive at a rate higher than the SCR. If the burst is
larger than anticipated, the additional cells are either tagged or dropped.
This parameter applies only to VBR traffic.
W | P
Numb (10)
Range=0-214748
3647 0
CDVT (microseconds) [raaz_cdvt]
Cell Delay Variation Tolerance establishes the time scale over which the
PCR is policed. This is set to allow for jitter (CDV).
W | P
Numb (10)
Range=0-214748
3647 0
Traffic Desc [raaz_tdtype]
This is the traffic descriptor type which describes the specified traffic
parameters for the service (for more information consult the ATM Service
Application Solutions Guide).
M | W | P
Enum (7) "None"
"ABR_FC"
"ABR_NFC"
"CBR.1"
"UBR.1"
"UBR.2"
"VBR.1"
"VBR.2"
"VBR.3" "Other"
Z to A Direction
Bandwidth (kbits/s) [srza_bandwidth]
This is the bandwidth consumed by the A endpoint in the Z to A direction.
M | W
Numb (10)
Range=0-214748
3647
Primary logical port [srz_primtp]
This is the logical port used as the primary Z side termination point when
this NC is using a backup UNI logical port.
R | A
Text (44)
Sustainable Cell Rate (cells/s) [raza_scr]
SCR is the maximum average cell transmission rate that is allowed over a
given period of time on a given circuit. It allows the network to allocate
sufficient resources for guaranteeing the network performance objectives
are met.
W | P
Numb (10)
Range=0-214748
3647 0
Peak Cell Rate (cells/s) [raza_pcr]
PCR is the maximum allowed cell transmission rate. It defines the shortest
time period between cells and provides the highest guarantee that network
performance objectives (based on cell loss ratio) will be met.
W | P
Numb (10)
Range=0-214748
3647 0
Table A-8 Cross Connection (continued)
Attributes Acceptable
Values Default Values