Cisco 6400 - Manual (Page 50)

A-50
Cisco 6400 Equipment Module Configuration Guide
OL-1812-01
Appendix A Attribute Reference
Cross Connection Profile
Sustainable Cell Rate (cells/s) [raaz_scr]
SCR is the maximum average cell transmission rate that is allowed over
a given period of time on a given circuit. It allows the network to
allocate sufficient resources for guaranteeing the network performance
objectives are met.
W
Peak Cell Rate (cells/s) [raaz_pcr]
PCR is the maximum allowed cell transmission rate. It defines the
shortest time period between cells and provides the highest guarantee
that network performance objectives (based on cell loss ratio) will be
met.
W
Numb (10)
Range=0-214748364
7 0
Minimum Cell Rate (cells/s) [raaz_mcr]
MCR is the minimum cell rate, which is the minimum allocated
bandwidth for a connection.
W
Numb (10)
Range=0-214748364
7 0
Maximum Burst Size (cells) [raaz_mbs]
MBS is the maximum number of cells that can be received at the PCR.
This allows a burst of cells to arrive at a rate higher than the SCR. If
the burst is larger than anticipated, the additional cells are either tagged
or dropped. This parameter applies only to VBR traffic.
W
Numb (10)
Range=0-214748364
7 0
CDVT (microseconds) [raaz_cdvt]
Cell Delay Variation Tolerance establishes the time scale over which
the PCR is policed. This is set to allow for jitter (CDV).
W
Numb (10)
Range=0-214748364
7 0
Traffic Desc [raaz_tdtype]
This is the traffic descriptor type which describes the specified traffic
parameters for the service (for more information consult the ATM
Service Application Solutions Guide).
M | W
Enum (7) "None"
"ABR_FC"
"ABR_NFC"
"CBR.1" "UBR.1"
"UBR.2" "VBR.1"
"VBR.2" "VBR.3"
"Other"
Z to A Direction
Bandwidth (kbits/s) [srza_bandwidth]
This is the bandwidth consumed by the Z endpoint for the ZA
direction.
Numb (10)
Range=0-214748364
7
Primary logical port [srz_primtp]
The original logical port that is being backed up by UNI resiliency
(nodename/portname).
Text (44)
Table A-25 Cross Connection Profile (continued)
Attributes Acceptable Values Default Values