Cisco 6400 - Manual (Page 27)

A-27
Cisco 6400 Equipment Module Configuration Guide
OL-1812-01
Appendix A Attribute Reference
Multihop Tunnel
Remote Tunnel Name [rtunnel]
The tunnel name for the counterpart at the LAC. This attribute applies
to only MHIT).
W
Text (64)
Remote Tunnel Password [rpassword]
The remote tunnel password (MHIT only).
W
Text (32)
Authentication Type [authentication]
This is the authentication type.
W
ms-chap, pap, chap,
callin, optional,
one-time (or a
combination of these
in the correct
sequence)
Enable IP Processing Without an Explicit IP Address [c4_vt_ipaddr]
Specify the interface that you want IP enabled on without assigning a
specific IP address (i.e. fastethernet 0/0/0). This attribute is used
when configuring a virtual template to assign PPP features to a PVC.
W
Text (40)
Dial In/Out [dial_type]
This is the dial type for the tunnel.
W
Enum (8) dial_in,
dial_out, other
Tunnel Type [tunneltype]
Specify the tunnel type.
W
Enum (5) l2tp, 12f,
pppoe
Contained/Carried By
LPort [c4lport.srname]
The logical port that contains the tunnel.
R
Text (32)
Node [c4node.srname]
The node that contains the tunnel.
R
Text (32)
Network [c4node.srnetwork.srname]
The network that contains the tunnel.
R
Text (32)
Virtual Template [c4vt.vtindex]
A pointer to the virtual template. This attribute is required for dial_in
type tunnels.
R
Text (32)
Table A-11 Multihop Tunnel (continued)
Attributes Acceptable Values Default Values