SINGER 1050 - Manual (Page 33)

Curved Seams
• Use a short stitch for elasticity and strength. For example,
if the stitch length control on your machine is set on 2
for straight seams, adjust the control between 1.5 to 2 to
stitch curved seams in the same fabric.
• If you use the seam guide, attach it at an angle so that the
edge that is closer to the needle acts as a guide.
Reinforcing End of Seam
• stitch to the edge of the fabric. (Do not sew beyond edge
of fabric)
• Press reverse stitch button and hold in place. Backstitch
approximately 1.5 cm (’/2 inch) to reinforce end of seam.
Release reverse stitch button.
• Raise needle and take-up lever to highest position by
turning hand wheel toward you and raise presser foot.
Remove the fabric by drawing it to the back and left.
• Cut threads on thread cutter at rear of presser bar.
! +
II
o o
& :i'
^ III
32