Cutting button opening – SINGER 1050 User Manual
Page 72
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
10. Set the stitch length control within red buttonhole area.
Start machine and if needed, adjust stitch appearance of
this side of buttonhole to match left side within the red
buttonhole area of stitch length control. Turn dial to the
right to open stitches or left to close up the stitches.
10
11
11. Stop sewing when stitching reaches the starting bar tack,
e
Remove work from machine, secure and clip thread ends.
12
• Switch machine off.
12. Remove two-step measuring foot by snapping down L.
Cutting Button Opening
e
Place a pin across the cutting space at each end of the
buttonhole to protect bar tacks.
• Use a pair of small, sharp scissors to cut the button
opening M.
• Insert blade in centre of the buttonhole cutting space and
cut from this point in both directions.
71