Winding bobbin, Devanado de la canilla, Preparation de la canette – SINGER 118 FEATHERWEIGHT II User Manual

Page 12: Devanado de ia caniiia, Préparation de ia canette

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

WINDING BOBBIN

1. Place a spool of thread on the spool

pin. Secure it with the spool cap to
ensure smooth flow of thread.

2. Pass thread from spool through thread

guides as shown.

3.

Puli end of thread through hole in

bobbin as shown.

4.

Push bobbin winder shaft to far left

position, if it is not already there. Place
bobbin onto shaft with end of thread
coming from top of bobbin. Push bobbin

winder shaft to right until it clicks. Hold
onto end of thread.

5. Start machine. The thread that is held

will snap or may be trimmed with a

scissor. Bobbin will cease turning when
completely filled. Push shaft to left to
remove bobbin.

l O

DEVANADO DE LA CANILLA

1.

Colocar un carrete de hilo en el

portacarretes. Asegurarlo con la tapa
portacarretes,

para

garantizar

una

salida suave del hilo.

2. Pasar el hilo desde el carrete, a través

del guía hilo, tal como está mostrado.

3. Estirar el extremo del hilo, a través del

agujero en la canilla, tal como está
mostrado.

4.

Empujar el eje del devanador canilla

hacia la posición maxima izquierda, si
no está ya ahi. Colocar la canilla en el
eje, con el extremo del hilo saliendo
por la parte superior de la canilla.
Empujar hacia la derecha el eje del
devanador, hasta que se sienta un
golpe seco. Retener el extremo del hilo.

5. Poner en maroha la máquina. El hilo

que está retenido se soltará. La canilla
cesará de girar cuando se haya llenado

por

completo.

Empujar

hacia

la

izquierda el eje para sacar la canilla.

PREPARATION DE LA

CANETTE

1. Plaçez une rouleau de fil sur le porte-

bobine. Bloquez-la avec le couvre-fil

afin d’assurer le bon déroulement du

fil.

2. Passer le fil dans le guide fil comme

illustré.

3. Introduire le fil dans un des trous de la

canette.

4.

Pousser l’axe du dévidoir vers la

gauche, placer la canette sur cet axe.

Pousser le tout vers la droite jusqu’au

déclic. Tenir le bout de fil.

5.

Mettre la machine en marche. La

canette va se remplir. Continuer à tirer

sur le bout de fil et il va se couper.

Dès que la canette est pleine, elle

s’arrêtera de tourner. Pousser la canette
vers la gauche pour pouvoir enlever la

canette.

Advertising