SINGER 14U 34B/234B User Manual

Page 24

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

• 3-Thread pin tucking

Pin tucking is a useful decoration when sewing blouses and children’s clothes. Pin tucking is accomplished
before cutting out garment.

• Use ordinary overedge throat plate or rolled hemming throat plate.

• Remove left needle.

• Before sewing on your garment, always make a test stitch on a sample of your fabric so that you can

adjust the thread tensions correctly for standard 1 needle, 3 thread overedge stitching.

. Place movable knife in non-operating position.

• Fold fabric in half with the wrong side facing.

• Place fabric under the foot with the fold resting against the wall of edge guide, (optional parts)

• Adjust edge guide (optional parts) so that the stitches will just overcast the edge of the fold as shown in

the sketch.

• Lower the foot and sew. When stitching is completed, press pin tuck to lay flat on one side.

• Turning square corners

Outside corner

1. Cut out approximately

2cm from the comer in

line with the overedge

seam edge.

2. Sew to point A, one stitch

beyond edge of fabric and
stop machine.

3. Raise needle and presser


4. Pull fabric to the rear of

machine just enough to

release the thread caught
on the finger of the throat


5. Turn fabric and lower

presser foot so that its
finger is positioned on the
edge of fabric.

6. Pull slack threads up, then

start to sew.


This manual is related to the following products: