Preparation prior to sewing, Warning – SINGER 14U 34B/234B User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
2. Preparation prior to sewing
Connect the machine plug to the electrical receptacle of your machine and the power line plug to the wall
receptacle.
For 120/220/240V
Power switch
(used also for light switch)
Push "I” mark side
to turn "ON"
Push "O" mark side
to turn "OFF"
Controller
For 120V
Power switch
(used also for light switch)
When the switch is ON,
the red mark on the knob
is visible
Power line plug
Wall receptacle
To run the machine and control the speed, press the speed controller. The harder you press, the faster the
machine will sew. To stop the machine from sewing, remove your foot from the speed controller.
Warning:
•
Be sure that the electrical voltage of the socket outlet (wall receptacle) is the same as the rated voltage of
the motor.
•
Handle the foot controller with care and avoid dropping it on the floor. Be sure not to place anything
on top of it.
•
Disconnect the power-line plug from the socket outlet when changing needles, presser feet or throat
plates, or when leaving the machine unattended. This eliminates the possibility of starting the machine
by accidentally pressing the speed controller.
• Before cleaning your machine, disconnect the power-line plug from the socket outlet.