Threading the machine, C'tm – SINGER 14U 34B/234B User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
3. Threading the machine
• Setting up the thread guide holder
c'Tm
• How to open looper cover
Extend the thread guide holder as far as possible
and set the thread guides so that they are located
right above the spool pins.
Place the thread on the spool stand as shown
above.
• How to remove cylinder cover
0 While pulling the cylinder cover to the left,
(2) Lift cover upward and off the machine.
0 Push the cover to the right as
far as it will go and
@ Pull cover down toward you.
Caution:
* Be sure looper cover is closed when sewing.
To replace cover
0 Place tab on top of cover under the
throat plate.
0 Press cover downward to the right.
Warning:
Do not hold the cylinder cover when lifting or carrying the machine.
Caution:
Be sure cylinder cover is replaced when sewing.