To replace bobbin case – SINGER 319K User Manual
Page 24
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
22
TO THREAD BOBBIN CASE
TO REPLACE BOBBIN CASE
1. Hold bobbin so that thread will unwind in
direction shown.
Hold bobbin case as shown above and place
bobbin into it.
2. Pull thread into slot K, under tension
spring L and into slot M at end of spring.
Allow about three inches of thread to hang
free from bobbin case.
ci:::::®
Fig. 20
3. Grasp bobbin case between left thumb and
forefinger at latch hinge point as shown.
Tilt right edge of bobbin case slightly to en
gage post.
Fig. 21
4. Release bobbin case and press forefinger
against bobbin case until it snaps in place as
shown.
Advertising
This manual is related to the following products: