To start at given place in a design – SINGER 319K User Manual
Page 31
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
29
SATIN STITCHING—(Continued)
While stitching on a scrap of material, set
stitch regulator lever at 25, then carefully and
slowly turn limit screw R until stitches are
placed closely together, allowing material to
feed smoothly and evenly without irregularity.
The exact setting of the stitch length for
closed satin stitching will vary with the tex
ture of the fabric, the amount of needle and
bobbin thread tension, and with the operator
depending upon whether she holds the fabric
firmly or lightly. A light tension and light even
handling are recommended for satin stitching.
Foot 105251 provides a channel for satin
stitching and gives smooth uniform results.
TO START AT GIVEN PLACE IN A DESIGN
Stitch on a scrap of material until that point
in the design is reached which is to be repro
duced. Remove scrap from under the foot.
e2S7BS
Loosely woven or soft fabrics give best results
when backed with crisp lawn. This backing is
cut away close to the stitching when work is
completed.
Where satin or design stitching is to be done
on a single thickness of the garment, a backing
is essential on most fabrics.
Fig. 43
Fig. 44
Place work under needle. Position needle,
hold thread ends, drop presser foot and stitch.
This procedure is recommended for scalloping
and precise design stitching with all FASHION
Discs.