Placing bobbin – SINGER W610 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
PLACING BOBBIN
IN SHUTTLE
Open hinged cover plate left of the needle (See
18, Fig. 1). Hold the bobbin case latch (D, Fig.
9), between the thumb and forefinger of the
left hand, with at least three inches of thread
running from the top of the bobbin case to the
right. Insert and center the bobbin case on the
stud
of
the
shuttle
body
(C).
Be
sure
the
bobbin case finger (E) is opposite the shuttle
race notch (A). Press the bobbin case (B) into
the shuttle as far as possible until latch catches
on the center post of the shuttle. THEN re
lease the bobbin case latch (D). Press bobbin
case again after latch has been released to
make sure the bobbin case is hooked securely
in place. Close the cover plate.
A
Fig. 9
Fig. 10