SINGER W610 User Manual
Page 37
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
35
ATTACHMENT FOOT
In order to attach the binder, edgestitcher and the hem-
mers, it is necessary to remove the presser foot and
replace
it
with
the
attachment
foot
(Fig.
60).
Mount
binder, edgestitcher or hemmers, sliding the attachment
to the left as far as possible and tighten screw.
The mounting slot enables you to sew as close to or as
far away from the edge as desired. Just move the at
tachment
to
the
correct
position
before
tightening
the
mounting screw.
Fig. 60
EDGESTITCHER
The edgestitcher is used in mak
ing dainty lace insertions, edg
ings and pipings. The slots in
the edgestitcher serve as guides
in sewing together various pieces
of material. If you want to sew
lace, lace and embroidery, or lace
and tucked strips together, place
the piece of material that will be
on top in slot 1 (Fig. 62) and the
lower fabric in slot 4. For instance, if you are sewing lace edging to a finished edge of
fabric place the fabric in slot 1 and the lace in slot 4 (Fig. 61).
Be sure to draw the lace and material under the needle and back of the edgestitcher so
that the feed will carry it backward as you stitch. Hold the fabric in the left hand and the
lace in the right, being sure the fabric overlaps the lace slightly.
Fig. 61
Fig. 62