Of hemmers, Hemmer set, Hemmer set g – SINGER W610 User Manual
Page 40: Mijifkii, The of hemmers
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Before attaching any of the hemmers, be sure bobbin
thread is pulled up. Then, with hemmer in place, hold
top thread loosely and turn hand wheel one full turn
toward you, making a loop under hemmer. Grasp bob
bin thread with both hands and slip horizontally under
and carry upper thread to back of hemmer.
Fold material to suit for two inches along edge, hold at
each end of fold. Slip fold into guide and up over spoon
(Fig. 71). Fold hem in material back of hemmer. Draw
forward to end of hem and fasten with point of needle.
Pull on threads gently as you start stitching.
You can make a hem 1/4 inch, 3/8 inch, 5/8 inch or 7/8 inch in width, depending upon which
hemmer you use. For a few of the many uses see Figs. 72~77.
F i g . 7 3