SINGER W610 - Manual (Page 39)

BINDER
This attachment folds bias bindings and applies it
to the edge of material in one operation. Slots on
scroll of the binder are for corresponding widths of
commercial folded bias binding. The open mouth of
binder scroll is used for unfolded bias strips cut
15/16 Inch wide.
FOLDED BINDING (Fig. 69)
Cut a point on folded binding, insert in appropriate
slot. Draw through slot and under binder with strong
pin. Test stitching to be sure it is on the edge.
Adjust by sliding binder to right or left.
TWO-TONE BINDING (Fig. 70)
Two bindings can be sewn on fabric edge also in
one operation. When two are used, always skip one
size between widths, inserting each in correct size
slot.
HAND-CUT BIAS BINDING
Cut 15/16 inch bias binding fold in half for a couple
of inches. Cut binding (diagonally toward end, al­
most to fold). Slip fold into center of binder. Draw
back until cut opens and binding encircles open end
of scroll. Test stitching to be sure it is on the edge.
Adjust if necessary. See Fig. 67 and 68 for sug­
gestions on how to use the binder There are hund­
reds of other uses.
37
Fig. 67 Fig. 68
Fig. 70