Upper threading (fig. 10) – SINGER W610 User Manual
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
UPPER THREADING (Fig. 10)
Turn the hand wheel toward you to raise the take-
up lever and needle to their highest position.
Place spool of thread on the spool pin near the
Down and between tension discs (B)from right to
Up and around into the notch on check spring (C)
over tension discs.
6. Down under thread guide bar and into guide (D).
Up into take-up lever from right to left (E).
8. Down through guide (D) in thread bar again
into thread guide (F).
Through needle clamp guide (Q) and into needle from left to right pulling three to four
inches of thread through needle.
Hold the end of upper thread loosely and turn hand wheel toward you until the needle goes
all the way down and comes back up. A loop will be formed over the upper thread which
then can be pulled out straight (Fig. 11). Place both thread ends under the slot of the presser
foot and toward the back of the machine, leaving both threads three or four inches long.