SINGER White 5500 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Raise presser foot lifter and needle bar
(1)
Raise the presser foot lifter.
(2) Set the needle bar in the highest position
by turning the handwheel toward you.
Changing a foot
Snap-on presser foot
Step-1
Step-2
Step-3
presser foot
Push the lever of the
holder in the arrow
direction.
Position a new foot
with
the
pin right
under the groove of
the holder.
By lowering the pres
ser foot lifter, the foot
will be automatically
snapped on.
»When you fail to catch
the foot, press the
lever slightly.
Screw-snap presser foot {darning foot)
Step-1
Remove the foot and
the holder by loosen
ing the screw with a
screwdriver.
screw
Step-2
,7
darning
Step-3
ever of
the foot
Align the hole of the
darning foot with the
hole of the needle
plate.
Lower the needle by
turning the handwheel
toward you.
The lever of the foot
should be behind the
needle clamp screw.
Tighten the screw on
the holder.