Sewing on buttons (for model- 3 dials) – SINGER 6510 Scholastic User Manual
Page 32
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Move the drop feed control to right side to lower the feed
dogs.(1)
Change presser foot to button sewing foot (2). Select zig zag
pattern ( I )•
Position the work under the foot. Place the button in the desired
position, lower the foot, adjust stitch width to "0" and sew a few
securing stitches. Adjust the stitch width to "3". Turn the
handwheel to check that the needle goes cleanly into the left
and right holes of the button (adjust the stitch width according
to the button), and slowly sew on the button with about 10
stitches. Adjust the stitch width to "0" and sew a few securing
stitches (3).
If a shank is required, place a darning needle on top of the
button and sew (4). For buttons with 4 holes, sew through the
front two holes first (3), push work forward and then sew
through the back two holes (4).
□ Sewing on buttons (For model- 3 dials)
29