ADLINK PCI-9524 - Manual (Page 13)

List of Figures xiii
ADLINK Technology Inc. PCI-9524
Copyright 2008 User’s Manual
List of Figures
Figure 1-1: PCI-9524 Product Image ................................................. 1
Figure 1-2: Effective-number-of-bits vs. Gain .................................... 9
Figure 1-3: RMS Noise in µV vs. Gain ............................................... 9
Figure 1-4: Spectral Response ±10 V range,
0.996094 Hz sine wave, -1 dB FS ................................. 10
Figure 1-5: Spectral Response ±5 V range,
0.996094 Hz sine wave, -1 dB FS ................................. 10
Figure 1-6: Spectral Response ±2.5 V range,
0.996094 Hz sine wave, -1 dB FS ................................. 11
Figure 1-7: Spectral Response ±1.25 V range,
0.996094 Hz sine wave, -1 dB FS ................................. 11
Figure 1-8: Frequency Response Sampling at 30,000 SPS ............ 12
Figure 1-9: Frequency Response Sampling at 15,000 SPS ............ 12
Figure 1-10: Frequency Response Sampling below 15,000 SPS ...... 13
Figure 2-1: PCI-9524 PCB Layout and Mechanical Drawing ........... 23
Figure 3-1: CN1 Connector & Pin Assignments............................... 28
Figure 3-4: Connecting to a four-terminal load-cell transducer
using a four-wire connection.......................................... 34
Figure 3-5: Connecting to a six-terminal load-cell transducer
using a six-wire connection............................................ 35
Figure 3-6: Connecting to a four-terminal load-cell transducer
using a six-wire connection............................................ 36
Figure 3-7: Ground-referenced source and differential input ........... 36
Figure 3-8: Floating source and differential input............................. 37
Figure 3-9: Connecting to an external encoder
with NPN sink drivers..................................................... 40
Figure 3-10: Connecting to an external encoder
with PNP source drivers ................................................ 40
Figure 3-11: Connecting to an external encoder
with push-pull source drivers ......................................... 41
Figure 3-12: Connecting to an external encoder
with differential line-drivers ............................................ 41
Figure 3-13: Connecting to an external servo-amplifier
with opto-coupler inputs................................................. 42
Figure 3-14: Connecting to an external servo-amplifier
with differential line-receivers ........................................ 42
Figure 3-15: Connecting to an external resistive load
from the isolated DO sink driver .................................... 43