ADLINK PCI-8124-C - Manual (Page 96)

86 Function Library
6.13 Interrupt
@ Name
@ Description
_8124_set_int_factor:
This function is used to enable/disable the interrupt source.
Users can use the function, “_8124_wait_single_int” to wait the
specified interrupt. The following table shows the architecture
of interrupt factor of each channel.
(*): reserved bit (set to 0)
_8124_get_int_factor:
This function is used to get current configuration of interrupt
factors in your card.
_8124_wait_single_int:
When the user enabled the interrupt function for specified fac-
tors by “_8124_set_int_factor”, it could use this function to wait
a specific interrupt. When this function was running, the pro-
cess would never stop until the event was be triggered or the
_8124_set_int_factor Set (Enable) the interrupt factors
_8124_get_int_factor Get the setting of interrupt factors
_8124_wait_single_int Wait the single interrupt event
_8124_reset_int
Set the interrupt event to a non-signaled
state
Bit 0 1 2 3 4 5 6 7 8 9
CH
0 PWM0 FIFO0 Level FIFO0 Empty FIFO_0 Full LTC0 TTL-IN0 -(*) - - -
1 PWM1 FIFO1 Level FIFO1 Empty FIFO1 Full LTC1 TTL-IN1 - - - -
2 PWM2 FIFO2 Level FIFO2 Empty FIFO2 Full LTC2 TTL-IN2 - - - -
3 PWM3 FIFO3 Level FIFO3 Empty FIFO3 Full LTC3 TTL-IN3 - - - -
4 LIN0 LIN1 LIN2 LIN3 LIN4 LIN5 LIN6 LIN7 LIN8 LIN9