Bimba IntelliSens - Manual (Page 34)

IntelliSense ® Manual
34
Using IntelliSense ®
Sensor Interface Module Lights
Boot load mode
If the SIM is connected to a Data Gateway or a PC running the IntelliSense ® software when it
enters Boot load mode, the SIM will check if firmware update is available on the Gateway or
PC. While the SIM is checking for the latest firmware, Status 1 and Status 2 will be lit. After the
firmware update, the SIM will check that the installed firmware is valid. During this time, Status 1
will be lit. If the firmware fails, the check it will automatically restart the boot load process. If the
firmware fails a second time, Status 1, Status 2, and Status 3 will be lit. Go to bimba.com for the
latest firmware. When the check is successful, the SIM will enter Application mode.
Application Mode
Figure 41: Operation of Status Lights in Cylinder Monitoring Mode
Figure 42: Operation of Status Lights in Pressure/Temperature Monitoring Mode