Bonaire Touchpad - Manual (Page 31)

M ULTI -A PPLIANCE T OUCH P AD
Ducted Evaporative Air Conditioning
T HERMOSTAT M ODE
Step 1 Press the ON / OFF button to turn the
unit on.
Step 2 Check the Appliance is selected as
COOL.
Step 3 To select the THERM (Thermostat)
mode touch anywhere in the MODE
outline.
Step 4 Press THERM and the selected icon will
stop flashing. The remaining icons will
flash 5 more times and then disappear.
Step 5 To adjust the comfort level use the
arrows. Increase the
graphics scale for more cooling,
decrease for less cooling.
Note: The comfort level is individual to each situation and location. Some trial and error may be required
to set the graphic scale to your desired comfort level; a good starting point is to have the scale set at
approximately the half way mark. Once the unit has been set, the fan speed and pump are controlled
automatically. The unit can be left and will cycle on and off to keep the area being cooled to the set
comfort level.
P ROGRAM M ODE
Step 1 Press the ON / OFF button to turn the
unit on.
Step 2 Check the Appliance is selected as
COOL.
Step 3 To Select the PRGM (Program) mode
touch anywhere within the MODE
outline.
Step 4 Press PGRM. The selected icon will
stop flashing and the remaining icons
will flash 5 more times and then
disappear. In addition the programmed
mode of operation icon will be displayed
when the program calls for it as well as
the period (1, 2, 3, or 4).
This function will only enable program mode. To setup the program parameters refer to the section
“Operating the Touch Pad – SETUP” to edit the settings.
Program Mode will only operate for a 24-hour period from activation and then the product will
cease to function until the unit is restarted or program is reactivated.
Bonaire Control Systems Page 31