Bonaire Touchpad - Manual (Page 54)

M ULTI -A PPLIANCE T OUCH P AD
Controls – Installation / Setup / Commissioning
U NIT - D UCTED E VAPORATIVE A IR C ONDITIONER
† The water supply line has been flushed to clear swarf and debris and is free of leaks.
† The tank is free of foreign matter and debris and the water isolating tap is turned ON.
† Water drainpipe work is completed and sealed.
† The water basin fills with water and the float valve closes correctly when the water level is 65-70mm
below the overflow level.
† The water pump operates correctly when turned ON at the controller.
† The Dialflo water bleed rate is adjusted to suit local water conditions.
† The Dump Valve. The tank drains correctly when unit turns off.
† The fan deck is correctly located and the fan blade spins freely.
† The fan operates through the entire speed range.
† The minimum fan speed is correctly set.
† Water distribution is even with the filter pads fitted and the air conditioner operating pump and fan.
D UCTWORK
† All ductwork is completed to plan, correctly supported and airtight, with no bend less than 1.5 x the
ductwork diameter.
† Air distribution checked, dampers are adjusted and all outlets correctly adjusted and wiped clean.
† All roof penetrations are fully sealed and watertight.
† Manhole cover replaced.
S ITE
† All rubbish has been removed from inside and on the roof.
C USTOMER H AND O VER
† The operation of the Controller.
† The need to open windows and doors for the correct operation of Fresh Air Conditioning
† The operation of the bleed or dumping system and it’s importance to operate all the time in ducted
evaporative air conditioning
† Maintenance requirements
Bonaire Control Systems Page 54