Bonaire Touchpad - Manual (Page 6)

M ULTI -A PPLIANCE T OUCH P AD
Introduction
Your Touch Pad Control is designed to automatically detect the appliances during the commissioning of the
unit by the installer. Controller options not required for your appliances will usually not be visible on your
Touch Pad display.
Additional control accessories that can be added to
your Touchpad control for enhanced operation
include:
Remote Thermostat – an extra thermostat that
can be connected in conjunction with the
Touchpad to individually control a zone motor in
a specified area of a ducted gas heating
system.
Home Automation – allows the unit to be
turned ON or OFF through most home security
systems.
Your Touch Pad is designed in Australia to suit
Australian conditions and will ensure that your
home is comfortable all year round.
GENERAL INFORMATION
I MPORTANT I NSTALLATION N OTICE
A licensed person is required to install Climate Technologies equipment. If the equipment is not installed in
accordance with the installation instructions and the governing body regulations, Climate Technologies
reserves the right to refuse service on non compliant installations.
Subject to state regulations and by laws a certificate of compliance must be issued for the electrical and
plumbing connections certifying that the work complies with all the relevant standards.
Note: Only a licensed person will have insurance protecting their workmanship.
D ATA L OCATION .
Your appliance model number, serial number and model description are located on the appliance data plate
on the end of the heater or inside the cooler in the vicinity of the electronic controls. These details should
also be in the warranty section of this booklet.
You will need this information, should your appliance require servicing, spare parts or just if you require
additional information about this product.
Bonaire Control System Page 6