EXFO FTB/IQS-88000 Series Power Blazer for FTB-2/2Pro/500/IQS-600 - Manual (Page 128)

Test Setup - Test Configurator, Timer, and System
116 FTB/IQS-88000 Series
EtherBERT, FC BERT, and Unframed BERT
EtherBERT, FC BERT, and Unframed BERT
From the Test menu, tap Setup, Test Configurator, and tap on the
EtherBERT, FC BERT, or Unframed BERT block.
LINK
Note: Available with OTN BERT test application with Ethernet client (EoOTN).
A green/red arrow is used to indicate the status of the link at the PCS level:

A green arrow indicates that the link is up.

A red arrow indicates alarms at the PCS level, the link is down.
The Local Fault Detected, Local Fault Received, Remote Fault,
LOBL1027B, Hi-BER1027B, and LOAML1027B alarms are displayed. Only
the Remote Fault alarm is displayed with GFP. Refer to Ethernet on
page 266, and Transcoding on page 309 for more information.
Restore < Test Application > Defaults
Note: Available with OTN BERT test application with Ethernet client (EoOTN).
Reverts the current test application to its default factory settings.
Pattern

Coupled RX to TX check box, when selected (default), couples both
the TX and RX signal with the same test pattern. The Coupled RX to
TX check box is selected and not configurable for Seed A, Seed B, and
PRBS31 Unscrambled patterns.

RX Pattern Analysis check box, when selected (default), monitors the
received traffic pattern and Round-Trip Latency. Even if this check box
is not available for FC BERT, the received traffic pattern and Round-Trip
Latency are monitored. See BER on page 257 for more information.