EXFO FTB/IQS-88000 Series Power Blazer for FTB-2/2Pro/500/IQS-600 - Manual (Page 329)

Test Results
Power Blazer 317
Alarms/Errors
Inject Button

Layer: Allows to select on which layer is the alarm/error to be
generated. Choices depend on the test application and its interface.

Lane, available with parallel interface, allows to select the physical
lane that will be used for the injection. Available for Interface, OTL, and
PCS layers only.

Type: Allows to select the type of injection, either Alarms or Errors.

Defect: Allows the selection of the alarm/error defect to be generated.
Choices depend on the selected Layer and Type. Refer to
Alarms/Errors on page 254 for more information.

Mode and Rate/Amount

Manual allows to enter the amount of manual error to be
generated: 1 (default) through 50 or 100 (depends on the selected
error).

Rate allows the selection of the injection rate for the selected error.
The rate must be within the minimum and maximum values
specified.

Max Rate generates the selected error to its theoretical maximum
rate.
Open/Close pop-up button Selected Alarm/Error
and status