Labconco RapidVap Vacuum, N2 and N2/48 Evaporation Systems 7910015 - Manual (Page 41)

37
Chapter 4: Using Your RapidVap
Product Service Domestic 1-800-522-7658, International 816-333-8811
Operating The RapidVap
Controls
Preheat:
To preheat the chamber, press the preheat button. The
LED next to the button will illuminate and the display
will show:
SP: XXC ACT: XXC
Press increase or decrease buttons until the desired set
point is displayed. The actual block temperature will be
displayed to the right. When power is being supplied to
the heaters, a bar under the actual temperature will
illuminate. The block will continue to preheat until
either the preheat button is pressed again or the run
button is pressed.
Select existing program:
Operating parameters can be stored in memory so
protocols can be repeated. Nine programs can be
stored. To select a program, press the set point select
button directly under the word “PROG.” An arrow will
point to the current program number indicating that this
set point can be altered. To change the program
number, press the increase or decrease button until the
desired program number is displayed. When the
program number is changed, all its set points will
change also to indicate the last entered parameters.
Pressing the “PROG” set point button will reset the
timer to the previous set point time.
Change speed set point:
To change the speed set point parameter, press the set
point select button directly under the word “SPEED.”
Arrows will point to the present set point. The speed
may be altered from 0 to 100% by pressing the increase
or decrease buttons. The last entered set point will be
stored in memory.