Labconco RapidVap Vacuum, N2 and N2/48 Evaporation Systems 7910015 - Manual (Page 7)

3
Product Service Domestic 1-800-522-7658, International 816-333-8811
Chapter 1: Introduction
Chapter 6: Modifying Your RapidVap describes how to
install other blocks and the optional lid heater.
Chapter 7: Troubleshooting contains a table of
problems you may encounter while using your
RapidVap, including the probable causes of the
problems, and suggested corrective actions.
Appendix A: RapidVap and RapidVap N
2
Components
contains labeled diagrams of the components of the
RapidVaps.
Appendix B: RapidVap Dimensions contains
comprehensive diagrams showing the dimensions for
the RapidVap and RapidVap N
2
.
Appendix C: RapidVap Specifications contains product
specifications. Wiring diagrams for both the 115V and
230V RapidVaps are also included.
Appendix D: RapidVap Accessories lists the part
numbers and descriptions of all of the accessories
available for your RapidVap.
Typographical Conventions
Recognizing the following typographical conventions
will help you understand and use this manual:
• Book, chapter, and section titles are shown in italic
type (e.g., Chapter 3: Getting Started).
• Steps required to perform a task are presented in a
numbered format.
• Comments located in the margins provide
suggestions, reminders, and references.
• Critical information is presented in boldface type in
paragraphs that are preceded by the exclamation
icon. Failure to comply with the information
following an exclamation icon may result in injury
to the user or permanent damage to your RapidVap.
!