Labconco RapidVap Vacuum, N2 and N2/48 Evaporation Systems 7910015 - Manual (Page 52)

48
Chapter 6: Modifying Your RapidVap
Product Service Domestic 1-800-522-7658, International 816-333-8811
mounting holes. Apply a small amount of heat transfer
grease supplied with the RapidVap to the end of the
temperature sensor probe that extends up from the
bottom of the chamber.
Position the block over the three studs in the chamber.
Install the flat washers and nuts or manifold guide rods.
Tighten securely.
Installing the Optional Lid
Heater
If a Lid Heater is to be added by the user, first
disconnect the main power cord to the RapidVap. Then
remove the existing lid by removing the two screws that
hold either the RH or LH hinge pivot support bracket.
Remove the bracket and then slide the lid assembly off
of the other bracket. Install the new lid with the heater
attached by reversing the process. Plug the jack
attached to the lid heater into the receptacle on the back
of the RapidVap. The lid heater will operate any time
the main power switch is on.
V