Laerdal HeartStart AED Trainer - Manual (Page 10)

9
ENGLISH
Running a Training Scenario
To run the selected training scenario, treat the Trainer exactly as you would
the HS1 Defibrillator.
1. Pull the handle or press the green On/Off button to turn on the Trainer.
2. Remove the clear protective lid from the training pads cartridge
and set it aside. Follow
the HeartStart Trainer’s
voice instructions.
3. If using a clothed
manikin, remove the
clothing as instructed.
4. Pull the tab at the top
of the training pads
cartridge to peel off
the resealable film
cover. Inside are two
adhesive pads on a
plastic liner. Lift the
pads out of the
cartridge and unwind
the wires from the well.
Peel one pad off the liner.
5. Place the pad on the manikin.
Press the pad down firmly.
Then peel and place the other pad.
PRECAUTION: Do not place the
training pads on a person.*
NOTE: Be sure that each pad is completely
removed from the liner before being
placed on the manikin.
6. Continue to follow Trainer instructions
for remainder of scenario.
7. When the scenario has been completed, or to stop a scenario in
process, press and hold the On/Off button until the Trainer turns off.
8. To repeat the same scenario, repack the pads as described below, then
begin again by pulling the green handle or pressing the green On/Off
button.To select a different scenario, press the i-button.
NOTE: If battery power is depleted, the Trainer will say REPLACE BATTERY when the
Trainer is turned on, at the completion of a training scenario, and when the Trainer is
turned off.The Trainer will continue to operate for a short time. Replace the batteries
as soon as possible to ensure correct Trainer behavior.
* A Precaution is a condition, hazard, or unsafe practice that could result in minor personal injury.
HeartSart trainer DfU 5681 C.qxd 14-11-06 15:20 Page 9
Copy Approved - Check Revision Before Use